Starting a Fire the Dead Easy Way with Wood Pellets!
The most efficient way how to start a fire in a woodstove
Kindling Cradle for starting a fire with wood pellets
for Wood burners, fire places and chimenea
light a fire using wood pellets
instead of expensive kindling wood
Advantages of starting a fire using wood
pellets:
•Woodpellets burn much quicker than kindling wood•The stove will provide heat much earlier•The fire wood is lit safely•wood pellets contain more energy as compared to fire wood.•Due to the higher energy the fire wood is even dried before being lit•the fire wood burns easier, cleaner and more ecological•Starting a fire is successfully accomplished every time•Wood pellets are a lot cheaper than kindling wood
Starting a fire in a wood burning stove:
•Put the KINDLING CRADLE ( wood pellet basket ) into the wood stove•Fill the KINDLING CRADLE with wood pellets•Add some gel fire starter or any other fire starters•Set the fire wood on top of the CRADLE•Light the fire starting gel or the fire starters•Close the door of the stove•Open the primary air vent (from underneath) and the secondary air vent from around•Reduce the primary air after a few minutes to prevent the wood from burning too quickly•Enjoy the fire!
The Traditional Method to Light a Fire in Wood Stoves
Every owner of a wood burner most likely already experienced that the wood didn’t catch fire properly and went out again. normally to start a fire some kindling wood plus newspaper or a few fire starters are placed at the bottom inside the stove. afterwards the fire wood is stacked on top and the newspaper or the fire starters are lit. Some people recommend to leave the door open slightly until the wood has caught fire and is burning securely. Yet doing so surely some smoke will enter into the room. It gets worse if the fire starters or the newspaper stops burning and the logs have not yet caught fire properly. If you want to give it a second try there is no choice but to open the door of the wood stove again thus exposing yourself to plenty of smoke and bringing tears to your eyes. Now one has to clean out the ashes and consider using more kindling wood or additional newspaper or extra fire starters to finally succeed to light a fire. If you don’t succeed maybe you will through in the towel until trying again a few days later.
How to Start a Fire With Wood Pellets and Kindling Cradle
Using Smartgoods4U’s kindling cradle you can avoid any trouble when starting a fire in a woodburner, in fire places or chimeneas.You just put the kindling cradle ( wood pellet basket ) into the woodstove or your fire place and fill it up to 2/3rds with woodpellets. If the fire wood is really dry a smaller quantity of pellets may be sufficient. Afterwards you put a small quantity of fire gel onto the wood pellets. Fire gel can be purchased at the supermarket or the internet. The gel should be of higher viscosity. As an alternative any other fire starter can be used as well.Now the fire wood is placed above the kindling cradle. The logs can be stacked according your preference. Then the gel or the fire starters can be lit and the stoves door can be closed. The wood pellets are catching fire rapidly. This will cause sufficient draft in the chimney and plenty of heat to further dry and preheat the fire wood similarly as the remaining embers would do too. Just after 3 minutes the logs burn on their own and after 10 minutes the fire is at full swing. Any other method for kindling a fire would take at least 30 more minutes.Because wood pellets are a lot cheaper compared to kindling wood you can even save money and the purchase of the kindling basket will pay off within a few weeks.Patent DE 202011005584 U1 listed in Google
•Order•Shipment
via AMAZONby AMAZON
SmartGoods4U is a participant in the Amazon EU Associates Programme, an affiliate advertising programme designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.co.uk
SmartGoods4U
•faster•safer•clean•easy•economical
First Video about the Kindling CradleHow to start a fire in a Wood Burning Stove
Starting a Fire the Dead Easy Way with Wood Pellets!
The most efficient way how
to start a fire in a woodstove
Kindling Cradle for starting a fire with wood pellets
for Wood burners, fire places and chimenea
Advantages of starting a fire using wood pellets:
•Woodpellets burn much quicker than kindling wood•The stove will provide heat much earlier•The fire wood is lit safely•wood pellets contain more energy as compared to fire wood.•Due to the higher energy the fire wood is even dried before being lit•the fire wood burns easier, cleaner and more ecological•Starting a fire is successfully accomplished every time•Wood pellets are a lot cheaper than kindling wood
Starting a fire in a wood burning stove:
•Put the KINDLING CRADLE ( wood pellet basket ) into the wood stove•Fill the KINDLING CRADLE with wood pellets•Add some gel fire starter or any other fire starters•Set the fire wood on top of the CRADLE•Light the fire starting gel or the fire starters•Close the door of the stove•Open the primary air vent (from underneath) and the secondary air vent from around•Reduce the primary air after a few minutes to prevent the wood from burning too quickly•Enjoy the fire!
The Traditional Method to Light a Fire in Wood
Stoves
Every owner of a wood burner most likely already experienced that the wood didn’t catch fire properly and went out again. normally to start a fire some kindling wood plus newspaper or a few fire starters are placed at the bottom inside the stove. afterwards the fire wood is stacked on top and the newspaper or the fire starters are lit. Some people recommend to leave the door open slightly until the wood has caught fire and is burning securely. Yet doing so surely some smoke will enter into the room. It gets worse if the fire starters or the newspaper stops burning and the logs have not yet caught fire properly. If you want to give it a second try there is no choice but to open the door of the wood stove again thus exposing yourself to plenty of smoke and bringing tears to your eyes. Now one has to clean out the ashes and consider using more kindling wood or additional newspaper or extra fire starters to finally succeed to light a fire. If you don’t succeed maybe you will through in the towel until trying again a few days later.
How to Start a Fire With Wood Pellets and
Kindling Cradle
Using Smartgoods4U’s kindling cradle you can avoid any trouble when starting a fire in a woodburner, in fire places or chimeneas.You just put the kindling cradle ( wood pellet basket ) into the woodstove or your fire place and fill it up to 2/3rds with woodpellets. If the fire wood is really dry a smaller quantity of pellets may be sufficient. Afterwards you put a small quantity of fire gel onto the wood pellets. Fire gel can be purchased at the supermarket or the internet. The gel should be of higher viscosity. As an alternative any other fire starter can be used as well.Now the fire wood is placed above the kindling cradle. The logs can be stacked according your preference. Then the gel or the fire starters can be lit and the stoves door can be closed. The wood pellets are catching fire rapidly. This will cause sufficient draft in the chimney and plenty of heat to further dry and preheat the fire wood similarly as the remaining embers would do too. Just after 3 minutes the logs burn on their own and after 10 minutes the fire is at full swing. Any other method for kindling a fire would take at least 30 more minutes.Because wood pellets are a lot cheaper compared to kindling wood you can even save money and the purchase of the kindling basket will pay off within a few weeks.Patent DE 202011005584 U1 listed in Google
SmartGoods4U is a participant in the Amazon EU Associates Programme, an affiliate advertising programme designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.co.uk
SmartGoods4U
light a fire using wood pellets
instead of expensive kindling wood
•faster•safer•clean•easy•economical
Starting a Fire the Dead Easy Way with Wood Pellets!
The most efficient way how to start a fire in a woodstove
Kindling Cradle for starting a fire with wood pellets
for Wood burners, fire places and chimenea
light a fire using wood pellets
instead of expensive kindling wood
Advantages of starting a fire using wood pellets:
•Woodpellets burn much quicker than kindling wood•The stove will provide heat much earlier•The fire wood is lit safely•wood pellets contain more energy as compared to fire wood.•Due to the higher energy the fire wood is even dried before being lit•the fire wood burns easier, cleaner and more ecological•Starting a fire is successfully accomplished every time•Wood pellets are a lot cheaper than kindling wood
Starting a fire in a wood burning stove:
•Put the KINDLING CRADLE into the wood stove•Fill the KINDLING CRADLE with wood pellets•Add some gel fire starter or any other fire starters•Set the fire wood on top of the CRADLE•Light the fire starting gel or the fire starters•Close the door of the stove•Open the primary air vent (from underneath) and the secondary air vent from around•Reduce the primary air after a few minutes to prevent the wood from burning too quickly•Enjoy the fire!
The Traditional Method to Light a Fire in Wood Stoves
Every owner of a wood burner most likely already experienced that the wood didn’t catch fire properly and went out again. normally to start a fire some kindling wood plus newspaper or a few fire starters are placed at the bottom inside the stove. afterwards the fire wood is stacked on top and the newspaper or the fire starters are lit. Some people recommend to leave the door open slightly until the wood has caught fire and is burning securely. Yet doing so surely some smoke will enter into the room. It gets worse if the fire starters or the newspaper stops burning and the logs have not yet caught fire properly. If you want to give it a second try there is no choice but to open the door of the wood stove again thus exposing yourself to plenty of smoke and bringing tears to your eyes. Now one has to clean out the ashes and consider using more kindling wood or additional newspaper or extra fire starters to finally succeed to light a fire. If you don’t succeed maybe you will through in the towel until trying again a few days later.
How to Start a Fire With Wood Pellets and Kindling Cradle
Using Smartgoods4U’s kindling cradle you can avoid any trouble when starting a fire in a woodburner, in fire places or chimeneas.You just put the kindling cradle ( wood pellet basket ) into the woodstove or your fire place and fill it up to 2/3rds with woodpellets. If the fire wood is really dry a smaller quantity of pellets may be sufficient. Afterwards you put a small quantity of fire gel onto the wood pellets. Fire gel can be purchased at the supermarket or the internet. The gel should be of higher viscosity. As an alternative any other fire starter can be used as well.Now the fire wood is placed above the kindling cradle. The logs can be stacked according your preference. Then the gel or the fire starters can be lit and the stoves door can be closed. The wood pellets are catching fire rapidly. This will cause sufficient draft in the chimney and plenty of heat to further dry and preheat the fire wood similarly as the remaining embers would do too. Just after 3 minutes the logs burn on their own and after 10 minutes the fire is at full swing. Any other method for kindling a fire would take at least 30 more minutes.Because wood pellets are a lot cheaper compared to kindling wood you can even save money and the purchase of the kindling basket will pay off within a few weeks.Patent DE 202011005584 U1 listed in Google
SmartGoods4U is a participant in the Amazon EU Associates Programme, an affiliate advertising programme designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.co.uk